Problem with control.
A fault is detected in the water level
sensor.
Jammed Key.
• Motor speed sensor problem.
High current detected.
Motor not running properly.
Temperature sensor problem.
High/Low voltage detected.
SilverCare
TM
control problem
Too many suds are detected during the
washing session.
The unit is put on hold until the suds
are reduced. Then, the unit will go back
to the operation.
When it finishes washing, End and
SUdS codes will blink in turn.
Call for service.
Call for service
Call for service
Restart the cycle pressing the Start/
Pause Button. If the code reappears,
call for service.
Restart the cycle.
If the code reappears, call for service.
Restart the cycle.
If the code reappears, call for service.
Restart the cycle.
If the code reappears, call for service.
To prevent it, cut down on detergents.
For any codes not listed above, call 1-800-726-7864
(1-800-SAMSUNG)
26 Troub eshooting
'_¥T448AAW-0_535A-0_
EN.indd
26
2008-05-06
;,2_L2_2:23:37