VITO PRO POWER VIBCLR20 Manual De Instrucciones página 32

Idiomas disponibles

Question/Problem - Cause

Causa

The belt sander does not switch on when you press the

"ON/OFF" switch:

• The battery is discharged;

• The "ON/OFF" switch electrical contacts are not in

good condition, or the switch does not work;

The

motor

makes

intermittently or runs slowly:

• "ON/OFF" switch electrical contacts are damaged;

• Mechanical parts are blocked;

• The belt sander is running over excessive pressure,

overloaded motor;

Body overheats:

• Overloaded machine;

• Poor assembly of the housing or pieces inside the belt

sander;

abnormal

sound,

Solution

• Recharge the battery;

• Repair or replace switch;

starts

• Repair or replace switch;

• Inspect the mechanical parts;

• Reduce the working pressure;

• Reduce working pressure;

• Check if there is any blockage;