TERMA VEO SMART WI-FI Manual página 17

SMART SYSTEM — BASIC INFORMATION ABOUT THE SYSTEM AND THE
APPLICATION
HEATING ZONES
In the application, a newly created ʻhouse' should be divided into heating
zones (e.g. rooms) to which individual devices are assigned. It is possible to
select a schedule and view telemetry data for each zone. The list of all zones
is visible to the user in the Zones tab. The view of a single zone contains
a set of actions and information available to the user.
The temperature presented in the center of the screen of a single zone is the
current measured temperature, while the value at the bottom is the set tem-
perature that depends on the mode in which the system is currently operating:
• if the Vacation mode is active, the Vacation mode temperature is displayed
• if the Smart Location is active, the temperature for the Smart Location is
displayed
• if at least one device is in the manual mode, the temperature set for the
manual mode is displayed — the
• otherwise, the temperature for a given time interval will be displayed ac-
cording to the schedule — icon
icon
EN
PRINCIPLES OF MEASURING THE TEMPERATURE
IN THE ROOM (IN THE ZONE):
• If there is a temperature and humidity sensor (VTS) in a zone, its indica-
tions are the basis for the temperature control for all devices in a given
zone (recommended configuration);
• If there is no VTS sensor in the zone, the devices will operate based on
the average of the sensor readings of each device (or one sensor if one
device is in the zone).
A more detailed description of the SMART System can be found on
www.termasmart.com
17