LG WM0642H Serie Guía Del Usuario E Instruciones Para Instalación página 32

TROU [ES OOTING
BEFORE CALLING FOR SERvicE (cont.)
Wrinkling
The display shows:
LIE
The display shows:
,t-|
CC
The display shows:
| n,- ,-c|
The display shows:
,1-|
LC
The display shows:
PF
• Washer not unloaded
promptly.
• Washer overloaded.
• Hot and cold water inlet
hoses are reversed.
. Load is too small.
• Load is out of balance.
• The washer has an imbalance
detection and correction
system. If individual heavy
articles are loaded (bath
mat, bath robe, etc.) and the
imbalance is too great, the
washer will make several
attempts to restart the spin
cycle. If an imbalance is still
detected, the washer will stop
and the error code will be
displayed.
• Control error.
• Water level is too high due to
a faulty water valve.
• The water level sensor is not
working correctly.
• Thermal overload protection
circuit in the motor has been
tripped.
• A power failure has occurred.
• Always remove items from the washer as soon as
the cycle is complete.
• The washer can be fully loaded but the drum should
not be tightly packed, and the door should close
easily.
• Hot water rinse can set wrinkles in garments. Check
the inlet hose connections.
• Add 1 or 2 similar items to help balance the load.
• Rearrange items to help balance the load.
. Unplug the washer and call for service.
. Close the water taps, unplug the washer, and call
for service.
• Close the water taps, unplug the washer, and call
for service.
. Allow the washer to stand for 30 minutes to allow the
motor to cool; then restart the cycle. If the LE error
code still appears, unplug the washer and call
for service.
• Restart the cycle.
52