Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLING
THE WHEEL
KIT
The wheel kit is designed to greatly improve the
portability of your generator.
NOTE: Wheel kit is not intended for over-the-road
use.
You will need a socket wrench with 1/2" or 13mm
sockets and a needle-nose
plier to install this kit.
Refer to illustration shown below and install the wheel
kit as follows:
•
Place the generator on a hard flat surface.
•
Stand at the engine end of the generator and
gently tilt the generator forward, high enough to
place wooden blocks beneath the cradle. This will
allow you to add the wheels.
•
Slide the axle through the holes in the brackets
provided on the generator cradle.
•
Slide one wheel and flat washer on each end of the
axle. Make sure the air inflation valve is outward.
Insert both retaining pins using the needle-nose
plier. Remove the wooden blocks.
•
Attach the vibration mounts to the support leg with
30mm capscrews, washers and lock nuts.
•
With the wheels on, you can now lift up the handle
end and attach the support leg with 20mm cap
screws and lock nuts.
•
Check each fastener to ensure it is secure.
Support
Vibration
Flatwasher
Locknut
_f
__.20mm
Capscrew
30mm Capscrew
Flatwasher
f
/
/
/
Retaining
Pin
Publicidad
