Publicidad
Idiomas disponibles
Idiomas disponibles
REMOVING
AND iNSTALLiNG
SLIDES
Slide Removal -
- The drawers in these units can be rearranged to fit your
specific needs. This means that drawers may be moved
or reptaced as desired. For example, a 6qnch drawer
may be replaced by a 2qnch and a 4qnch drawer, or
three 2qnch drawers.
- First remove the drawer (Refer to Operation A).
Lift and hold the spring retainer, and push the slide to-
ward the rear of the unit. The slide may now be removed.
Figure 7
Spring Retainer
Slide Installation
o
Place the slide in the appropriate position in the unit and
pull toward the front of the unit until the spring retainer
snaps into position and secures the slide.
For smooth operation, make sure that the drawers are
matched with their original slides.
LOCK
SYSTEM
Problem
The unit unlocks
but the drawers
still will not open.
The unit locks but
some drawers still
are not locked.
Cause
One or more
of the drawers
are hotding the
[ockbars from
releasing.
The cover on the
chest is holding
the tockbars from
releasing.
The release
cables are not
working.
The unit is leaning
too far forward.
One or more of
the drawers are
not competetly
closed.
Solution
Completely close
ati the drawers and
the iockbars will
release to open the
drawers.
Apply a downward-
pressure to the
top of the cover
to let the tockbars
release.
In an UNLOCKED
position and pull
the lock lever sev-
eral times.
Position the unit on
a level area.
Unlock the unit.
Close at[ drawers
completely. Retock
unit.
Publicidad
