Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING
o
Clean engine, batten/, seat, finish, etc.
of all foreign matter.
•
Clean debris from steering plate.
Debris can restrict clutch/brake pedal
shaft movement, causing belt slip and
loss o1 drive,
_t, CAUTION:
Avoid all pinch points and
movable
parts
___....
Clutch/brakepedal
-"-ji2/Clean
f
,/ top% _.j
Steering _
Plate__
SteeringSystem, Dash,
Fenderand MowerN_.ot Shown
°
Keep finished surfaces and wheels
free of all gasoline, oil, etc.
-
Protect painted surfaces with automo-
tive type wax.
We do not recommend using a garden hose
or pressure washer to clean your tractor
unless the engine and transmission are
covered to keep water out. Water in engine
or transmission will shorten the useful life of
your tractor. Use compressed air or a leaf
blower to remove grass, leaves and trash
from tractor and mower.
CAUTION:
I
Pinch
413 Points
DECK WASHOUT PORT
Your tractor's deck is equipped with a
washout port on its surface as part of its
deck wash system. It should be utilized af-
ter each use.
1.
Drive the tractor to a level, clear spot
on your lawn, near enough to a water
spigot for your garden hose to reach,
IMPORTANT:
Make certain the tractor's
discharge chute is directed AWAY from your
house, garage, parked cars, etc. Remove
bagger chute or mulch cover if attached.
2.
Make surethe attachment clutch control
is in the "DISENGAGED" position, set
the parking brake, and stop the engine.
3.
Thread the nozzle adapter (packaged
with your tractor's Operator's Manual)
onto the end of your garden hose.
4.
Pull back the lock collar of the nozzle
adapter and push the adapter onto the
deck washout port at the left end of the
mower deck, Release the lock collar to
lock the adapter on the nozzle.
2O
Nozz[e
Washout Port
IMPORTANT:
Tug hose ensuring
connec-
tion is secure.
5.
Turn the water on,
6.
While sitting in the operator's
position
on the tractor, re-start the engine and
place the throttle
lever in the Fast ",_"
position.
IMPORTANT:
Recheck
the area
making
certain the area is clear.
7.
Move
the tractor's
attachment
clutch
control
to the "ENGAGED"
position.
Remain
in the operator's
position
with the cutting deck engaged
until the
deck is cleaned.
8.
Move
the tractor's
attachment
clutch
control
to the "DISENGAGED"
posi-
tion, Turn the ignition
key to the STOP
position to turn the tractor's engine off.
Turn the water off.
9.
Pull back the lock collar of the nozzle
adapter to disconnect
the adapter from
the nozzle washout
port.
10. Move the tractor to a dry area, prefer-
ably a concrete
or paved area. Place
the attachment
clutch
control
in the
"ENGAGED"
position to remove excess
water and to help dry before putting the
tractor away.
_WARNING:
A broken or missing washout
fitting could expose you or others to thrown
objects from contact with the blade.
•
Replace broken or missing washoutfitting
immediately, prior to using mower again.
•
Plug any holes in mower with bolts and
Iocknuts,
Publicidad
