GE Advantium PSA9240 Manual Del Propietário página 30

Other Advantium Features
Advantium Oven
Turntable
On/OFF
Use this feature to keep the turntable from
turning when using a dish is too large to
rotate in the cavity.
TURNTABLE ON/OFF is not a permanent
setting.
Press the Settings pad, turn the dial to select
TURNTABLE ON/OFF and press the dial to
enter. Turn the dial to select TURNTABLE ON
or TURNTABLE OFF, press the dial to enter.
Note:
• The turntable will not turn off in Speedcook,
Broil, Toast, or Microwave Sensor modes.
A cooking cycle must be started within 5
minutes of turning the turnable off, or the
turntable will reset to the on setting.
The turntable will olso remain off for
cooking cycles started within 5 minutes of
the end of any cooking cycle for which the
turntable was off.
Auto Night
Light
Use this feature to set the surface light to
come on and go off at a certain time.
q.
.
.
Press the Settings pad, turn the dial to
select AUTO NIGHT LIGHT and press the
dial to enter.
Select SET ON TIME and press the dial to
enter.
Turn the dial to set on time hour and
minutes, press the dial to enter. Turn the
dial to set off time hour and minutes, press
the dial to enter. Note: Setting the hours
sets AM/PM.
To disable the Auto Night Light feature, press
the Settings pad, turn the dial to select AUTO
NIGHT LIGHT and press the dial to enter.
Turn the dial to select DEACTIVATE and press
the dial to enter.
To check the Auto Night Light on and off
times, press the Settings pad, turn the dial to
select AUTO NIGHT LIGHT and press the dial
to enter. Turn the dial to select REVIEW ON/
OFF TIMES and press the dial to enter. The
display will show the on and off time for the
Auto Night light.
Note:
Auto Night Light will turn on the surfoce
light to the night setting, when the clock
time matches the Auto Night Light on time,
even if the surface light is on the bright
setting.
Auto Night Light will always turn the
surface light off when the clock time
matches the Auto Night Light off time if the
surface light is turned on.
Temperature
Units
To change temperature units, press the
Settings pad and select TEMPERATURE UNITS.
Turn the dial to select F or C and press the
dial to enter.
Delay Start
Use this feature to delay when the oven will
start cooking in CONV BAKE, COOK BY TIME,
COOK BY TIME 1&2, DEFROST BY TIME, or
DEFROST BY WEIGHT.
1. Press the Options pad.
2. Turn the dial to select DELAY START and
press the dial to enter.
3. Turn the dial to set the start time hour and
minutes, press the dial to enter.
Note: Setting the hours sets AM/PM.
4. Set the cooking mode.
The oven will start the programmed cooking
mode when the clock time and the delay
start time are the same.
3O