Polar Q Serie Instrucciones De Uso página 8

Q-series chargers set as 'Power Supply' can be used as stabilised power supplies.
Using the Program Shooter, it is possible to set the maximum voltage and current that can
be provided. For example, if you set 25V 10A, the charger will supply a constant 25V
and limit the maximum current to 10A. Using the menu it is possible to set the voltage from
a minimum to a maximum depending on the rated voltage of the model in use.
P.Supply
Voltage
Voltage
P.Supply
Current
Current
Saving
Data?NO
After choosing the option to save the settings, wait until the message DATA STORED
appears, then remove the Program Shooter.
Duration: The warranty is valid for 12 months.
Effective date: The date of dispatch from the POLAR s.r.l. plant is the effective date.
Coverage: The warranty obliges the manufacturer POLAR s.r.l. to repair or replace
all components subject to ascertained defects without charge.
The POLAR assistance service is responsible for carrying out the repair or replacement
in the shortest possible time, in line with internal commitments and workload, without any
obligation of indemnity or compensation for direct or indirect damage.
The warranty does not cover: - Labor costs incurred by POLAR assistance service
and costs for any travel or transport - Consumables - Damage to property or persons
caused by misuse, tampering, incorrect installation, modifications not approved by
the manufacturer, inexperience or non-compliance with the rules contained in
the instructions for use and operation.
The warranty is void if: -The instructions contained in this manual have not been
observed. -The improper use or manipulation of the product has been ascertained.
- The battery charger has been used outside the parameters defined by product
specifications and its order. In the event of any defects, contact your authorized dealer.
Send for environmentally sound recycling packaging, discarded products and accessories.
For EU countries only:
Do not dispose of discarded products in household waste!
In conformity with The Waste Electrical and Electronic Equipment Directive
(WEEE Directive) 2012/19/EU and the implementation of the transposition
into national law, products that have become unusable must be collected
separately and sent to a waste treatment facility.
Description of the Power Supply mode menu
The power supply voltage setting.
Press to enter menu.
Turn to select the voltage.
E.g.: 30V
30V
Press to confirm.
The power supply current setting.
Press to enter menu.
Turn to select the current.
E.g.: 10A
10A
Press to confirm.
Saving the settings.
Menu Press to enter menu.
Turn to select whether to save
Save
the settings YES / NO.
Press to confirm.
WARRANTY
DISPOSAL
7.