BLACK&DECKER CE750 Manual De Instrucciones página 21

DRIVE BELT (Fig. L)
Warning! Turn off and unplug the tool before making any
adjustments or removing or installing accessories.
To Replace Belt
a. Loosen the three screws shown in Fig. L and remove the
belt cover.
b. Remove old belt.
c. Place new belt over front pulley then rotate belt clockwise
while pushing belt onto back pulley.
d. Attach belt cover and securely tighten screws.
MAINTENANCE
Your tool has been designed to operate over a long period
of time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance, switch off
and unplug the tool.
Cleaning
► Turn off and unplug unit before cleaning chip discharge
chute. Clean the chip discharge chute (6) regularly.
Always wear safety glasses.
Warning! For your own safety, turn switch OFF and remove plug from power outlet before adjusting or aligning your planner.
PROBLEM
Unit will not start.
► Never use solvents or other harsh chemicals for cleaning
SERVICE INFORMATION
Black & Decker offers a full network of company-owned
and authorized service locations. All Black & Decker Service
Centers are staffed with trained personnel to provide customers
with efficient and reliable power tool service. For more
information about our authorized service centers and if you
need technical advice, repair, or genuine factory replacement
parts, contact the Black & Decker location nearest you,
or visit us at www.BlackandDecker-la.com
SPECIFICATIONS
Power
Speed
Max. depth of cut
Rabbeting capacity
Shoe length
Planing width
3 Chamfer grooves
Cord
TROUBLESHOOTING
CAUSE
1. Cord not plugged in.
2. Circuit fuse is blown.
3. Circuit breaker is tripped.
4. Cord or switch is damaged.
the non-metallic parts of the tool. Use only mild soap and
damp cloth to clean the tool. Never let any liquid get
inside the tool; never immerse any part of the tool into
a liquid.
SOLUTION
1. Plug tool into a working outlet.
2. Replace circuit fuse. (If the product
repeatedly causes the circuit fuse to
blow, discontinue use immediately and
have it serviced at a Black & decker
service center or authorized servicer.)
3. Reset circuit breaker. (If the product
repeatedly causes the circuit breaker
to trip, discontinue use immediately
and have it serviced at a Black & Decker
service center or authorized servicer.)
4. Have cord or switch replaced at a
Black & Decker service center or
authorized servicer
ENGLISH • 21
CE750
750W
n 16500/min
0
2,0mm (5/64")
12mm (15/32")
29cm (11-½")
82,5mm (3-¼")
1,5/2,0/2,5 mm
2m