Publicidad
Idiomas disponibles
Idiomas disponibles
Your new tractor has been assembled at the factory with exception of those parts left
unassembledfor shipping purposes. To ensure safe and proper operationof your tractor
all parts and hardware you assemble must be tightened securely. Use the correct tools
as necessaryto
insure proper tightness.
ADJUST
SEAT
TOOLS
REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(2) 7/16" wrenches
Utility knife
(1) 1/2" wrench
Tire pressure gauge
(1) 3/4" wrench
Pliers
(1) 3/4" socket w/drive ratchet
1. Sit in seat.
2. Lift up adjustment lever (A) and slide seat
until a comfortable
position
is reached
which allows you to press clutch/brake
pedal all the way down.
3. Release lever to lock seat in position.
(1) 9/16" wrench
Flashlight
When right or left hand is mentioned
in this
manual, it meanswhen you are inthe operating
position (seated behind the steering wheel).
TO
REMOVE
TRACTOR
FROM
CARTON
UNPACK CARTON
•
Remove all accessible
loose parts and
parts cartons
from carton.
•
Cut along dotted lines on all four panels
of carton. Remove end panels and lay
side panels flat.
•
Remove mower and packing materials.
Check for any additional
loose parts or
cartons and remove.
BEFORE
REMOVING
TRACTOR
FROM
SKID
TO CHECK BATTERY
1. Lift hood to raised position.
NOTE: If this battery is put into service after
month and year indicated on label (label is
located between terminals)
charge battery
for minimum of one hour at 6-10 amps. (See
"BATTERY"
in Maintenance
section of this
manual for charging instructions).
•
Forbatteryand batterycableinstallationsee
"REPLACING
BATTERY" inthe "Service
and Adjustments"
section in this manual.
Label
NOTE:
You may now roll your tractor
offthe
skid. Follow the instructions
below to remove
the tractor
from the skid.
Ai_ WARNING:
Before
starting,
read,
un-
derstand
and follow
all instructions
in the
Operation
section
of this manual.
Be sure
tractor
is in a well-ventilated
area.
Be sure
the area in front of tractor
is clear of other
people
and objects.
TO ROLL TRACTOR
OFF SKID
(See
Operation
section
for location
and
function
of controls)
1.
Raise
attachment
lift lever to its highest
position.
2.
Release
parking
brake
by depressing
clutch/brake
pedal.
3.
Place
gearshift
lever in neutral
position.
4.
Roll tractor
forward
off skid.
Continue
with the instructions
that follow.
TO iNSTALL
MOWER
1.
SET
PARKING
BRAKE
LEVER
AND
LOWER
ATTACHMENT
LIFT
LEVER
•
Depress
clutch/brake
pedal
all the way
down
and hold.
Pull
parking
brake
lever
up and
hold,
release
pressure
from clutch/brake
pedal,
then release
parking
brake
lever.
Pedal
should
remain
in brake position.
Ensure
parking
brake
will
hold tractor
secure.
Brake
8
Publicidad
