Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING THE WATER COOLER
1. Cut and remove the straps from the case. DO NOT turn the case upside down or lay it on its
side. The bottom of the box is separate from the top section. Lift the top section of the box to
remove it. Remove the Styrofoam packaging and plastic bag. Lift the water cooler from the
bottom of the box. Clean it if necessary.
2. Place the machine on a hard, flat surface. Make sure the unit is level. The unit should not be
near direct sunlight or other heat source.
3. Make sure there is at least 4 inches of space between the back of your water cooler and the
wall. Maintain a minimum distance of 2 inches on each side of your water cooler.
WARNING: The drain cap on the back of the unit may become loose during shipping. Tighten
the drain cap securely before operating the unit. If the drain cap is loose, the unit may leak and
cause damage to the floor.
PREPARING THE WATER SOURCE FOR USE
This model of water cooler is different from a traditional water cooler. It is not necessary to place
the water bottle upside down on top of the unit. The water bottle is placed in the bottom cabinet
of the unit, and then a pump sucks the water into the dispenser.
As with a new refrigerator with ice maker or water dispenser, 1 or 2 full bottles of water are
recommended in the system before use.
Publicidad
