Publicidad
Idiomas disponibles
Idiomas disponibles
1.Make sure that the water dispenser is not plugged into an electrical outlet.
Open the lower cabinet door.
3.Place a full water bottle in the center of the cabinet. Remove the plastic
cap that covers the mouth of the water bottle.
4. Place the hose inside the water bottle and tighten the cap over the mouth
of the water bottle.
tightly the cap over the mouth of the water bottle. (Figure 1)
5.Connect the hose to the water cooler by depressing the knob on the hose
cap and sliding it over the connector on the top of the cabinet. (Figure 2)
6.Center the water bottle and close the bottom cabinet door.
7.Plug the water cooler into a grounded outlet and turn on the power switch
located on the back.
The unit will start to operate, but you should wait at least half an hour before
using the water cooler.
NOTE: If there is not a secure connection between the hose cap and the water cooler
connector, the water pump will operate, but the water cooler will not dispense water. Make
sure the hose is properly connected to the water cooler.
NOTE: Wait until the water pump stops running before using the unit. If the water tank is
not full, no water will come out of the cold-water faucet or the hot water faucet.
Figura 3
Publicidad
