Publicidad
Idiomas disponibles
Idiomas disponibles
PARTS DESCRIPTION
ASSEMBLING THE CUP
1. Place the rubber sealing ring (5) on the inside edge of the blade assembly (6).
2. Place the complete blade assembly on the base of the cup (7).
3. Insert the safety ring (4) into the bottom of the cup first, then insert the base of the complete cup into the bottom
of the cup and secure it firmly.
4. Mount the cup (3) onto the base (7) and rotate clockwise until the cup locks into place.
5. Fit the measuring cap (1) to the lid (2).
6. Attach the lid to the cup and press down.
INSERTING THE GLASS JAR
1. Make sure the blender is turned off. The knob (9) must be in position "0"
2. Place the assembled cup on the motor base (8) and press down until it locks firmly
USING THE BLENDER
1. Place the food you want to mix into the glass.
2. Put the lid on the cup and close tightly. Place the measuring cap in the lid and turn clockwise to lock it.
3. Turn on the device using the appropriate knob (9):
Speed
Usage
1-4
for light use with liquids
5
for a firmer consistency - for mixing liquids and solid foods
0
to stop any operation
P
for crushing ice and short, powerful impulse movements
(The operating knob is not activated permanently in the "PULSE" setting. It is necessary to hold down the switch in the
"PULSE" setting or rotate it repeatedly in the "M" setting)
After using the blender, always turn the knob to the "0" setting and remove the power plug.
To remove the cup, simply lift it from the motor base. It is not necessary to rotate the glass to remove it. Use
consecutively for up to 2 minutes, then allow the engine to cool before turning it back on.
When the appliance is turned off, the blade turns again for a moment: attention! The blades are very sharp: be
careful when cleaning them!
1. Measuring cap
2. Lid
3. Glass cup
4. Safety ring
5. Seal ring
6. Blade group
7. Glass base of the glass
8. Motor base
9. Function knob
7
Publicidad
