Uniteck UNIFIX 1.C 30 Manual Del Usuario página 13

ROOF PASS FIXING (PRODUCT NOT INCLUDED)
•
Drill a hole using a hole saw. Diameter between 15 and 20mm
•
Clean the fixing zone with the provided degreaser (do not use alcohol/white spirit...). Follow the
same operation on the roof-pass.
•
Put the provided glue on the area indicated in white on the picture below, then put it over the
drilling hole.
•
Pass the cables as seen on the picture below. Keep a sufficient length for the connection.
Tighten the nuts of the cable gland to ensure waterproofness
www.uniteck.fr
EN
13