Publicidad
Idiomas disponibles
Idiomas disponibles
GB
CAUTION
BEFORE CUTTING LARGE PIECES, PLEASE CHECK
THE SIZE TO BE CUT (CUT BEGINNING AND END)
COMPARED TO THE DISK.
With the EXTRA machine it is also possible to set out:
a) the cutting length with the cutting adjustment
knobs.
b) the cutting depth with the locking lever.
c) the straight cut measurement with the tile bearing
square as well as the ruler placed on the working
table.
In order to carry out special working it is possible
24
to set out any cutting inclination ranging from 0°
to 45° as marked on the machine side.
LASER MARKER
CAUTION
CLASS I 635 nm, < 5 mW LASER INSTRUMENT
By means of the laser marker accessory, the cutting
operations can be accelerated.
CAUTION
THE LASER MARKER STARTS WORKING ONCE THE
MACHINE IS CONNECTED TO THE POWER SUPPLY.
CUTTING WITH LASER MARKER
• connect the machine to the power supply;
• position the piece to be cut making sure that
the line indicated by the laser marker matches
the reference on the material to be cut;
• perform the cutting operation as indicated in
25
the paragraph: "cutting on the table"
CAUTION
DO NOT MODIFY THE MARKER POSITION BY
TURNING THE BEAM TOWARDS THE OPERATOR'S
EYES.
DO NOT GAZE AT THE BEAM WITH THE NAKED EYE
OR LOOK DIRECTLY WITH OPTICAL INSTRUMENTS.
ADJUSTMENT OF THE TRACER
28
In case the marker is not aligned with the cutting line,
its correct alignment can be adjusted.
In order to correctly position the marker, proceed as
follows:
• Loosen the three bulb locking screws so that it
26
can be moved.
• Position a reference properly on the tool
cutting line.
• Insert the 5 mm Allen wrench provided in the
26
hexagonal slot located on the bulb.
• Using the Allen wrench, turn the bulb until
aligning the mark with the tool cutting line.
CAUTION
DURING THE ADJUSTMENT OPERATIONS, MAKE
SURE THAT THE LINE PRODUCED BY THE MARKER
DOES NOT REACH THE OPERATOR'S EYES.
CAUTION
THE MANUFACTURER DECLINES ANY LIABILITY
FOR THE USE OF THE LASER MARKER IN
APPLICATIONS OTHER THAN THE INDICATED
APPLICATION.
CUTTING PROGRESS SYSTEM
27
The "CUTTING PROGRESS SYSTEM" can be
used to adjust – in a very precise manner and
by means of the hand wheel located on the
machine front upright – the cutting head forward
or backward movement.
CAUTION
GIVEN THE ACCESSORY HIGH SENSITIVITY,
PROCEED WITH CAUTION SO AS NOT TO
ACCIDENTALLY LOCK THE CUTTING TOOL.
RESIDUAL RISKS
During the design phase, BATTIPAV SRL paid
particular CAUTION to the aspects that may generate
risks for the safety and health of operators.
In spite of this, there are still some potential risks,
which are described below:
Battipav srl
Publicidad
