Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT SPECiFiCATiONS
MODEL NUMBER
SERIALNUMBER
DATE OF PURCHASE
GASOLINE
CAPACITY/TYPE:
OI LTYPE (API-SF/SGtSH):
917.37799t
OIL CAPACITY:
SPARK PLUG (GAP:
,030")
VALVE CLEARANCE:
SOLID STATE IGNITION
AIR GAP:
.0125 IN.
BLADE BOLT TORQUE:
35-40 FTo LBS.
1 o5QUARTS
UNLEADED
REGULAR
SAE 30 (ABOVE 32°F)
SAE 5W-30 (BELOW 32°F)
27 OZS.
CHAMPION
RJ19LM OR J19LM
INTAKE:
°004 - ,008
EXHAUST:
.004 - .008
o 'The modeJ and"seriai numbers wiirbe found on a decal attach'ed to
th8
rear o{_the
lawn mower housing.Record
both serial number and date of purchase
in space
provided
above,
LAWN MOWER
Always observe safety rules when performing
any maintenance°
TIRES
. Keep tires free of gasoline, oil, or insect
control chemicals which can harm rubber.
° Avoid stumps, stones, deep ruts, sharp
objects and other hazards that may cause
tire damage.
BLADE CARE
For best results, mower blade must be
kept sharp°
Replace bent or damaged
blades.
TO REMOVE BLADE
• Disconnect
spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
° Turn lawn mower on its side.
Make
sure air filter and carburetor are up.
• Use a wood block between blade and
mower housing to prevent blade from
turning when removing
blade bolt,
= Protect your hands with gloves and!or
wrap blade with heavy cloth.
- Remove blade bolt by tuming counter..
clockwise.
- Remove
blade and attaching hardware
(bolt, lock washer
and hardened
washer).
NOTE:
Remove the blade adapter and
check the key inside hub of blade adapter.
The key must be in good condition to work
properly.
Replace adapter if damaged,
TO REPLACE
BLADE
* Position the blade adapter on the
engine crankshaft°
Be sure key in
adapter and crankshaft
keyway are
aligned,
o Position blade on the blade adapter
aligning the two (2) holes in the blade
with the raised lugs on the adapter.
o Be sure the trailing edge of blade
(opposite sharp edge) is up toward the
engine.
° Install the blade bolt with the lock
washer and hardened
washer into
blade adapter and crankshaft.
o Use block of wood between blade and
lawn mower housing and tighten the
blade bolt, turning clockwise.
° The recommended
tightening
torque is
35-40 ft. Ibs.
11
Publicidad
