Craftsman 917.377991 Manual Del Usuario página 15

TO ASSEMBLE GRASS CATCHER
o insert leg of tubular frame through front
opening of grass catcher and thread
frame into sewn hem of bag.
NOTE: Keep bag hem gathered on the
straight leg of the tubular frame.
o When frame comes out the other end of
sewn hem, immediately work the end of
frame down inside the bag as shown in
inset.
o Slide sewn hem evenly around the
tubular frame until both ends of frame
are exposed out of the front opening.
• Assemble lower frame to tubular frame
as shown° Be sure handle is outside of
bag and frames are fully seated as
shown in inset.
o Slip vinyl bindings over frame°
NOTE: If vinyl bindings are too stiff, hold
them in warm water for a few minutes° If
bag gets wet, let it dry before using°
° Close the flip lid. Flip lid must be closed
while operating lawn mower.
,&CAUTION: Do not run your lawn mower
without clipping deflector or approved
grass catcher in place. Never attempt to
operate the lawn mower with the rear
door removed or propped open_
ENGINE SPEED
Your engine speed has been factory set,
Do not attempt to increase engine speed
or it may result in personal injury° If you
believe that the engine is running too fast
or too slow, take your lawn mower to an
authorized service center for repair and
adjustment.
CARBURETOR
Your carburetor has a non-adjustable
fixed main jet for mixture control° If your
engine does not operate properly due to
suspected carburetor problems, take your
lawn mower to an authorized service
center for repair and/or adjustment.
IMPORTANT: never tamper with the
engine governor, which is factory set for
proper engine speed_ Overspeeding the
engine above the factory high speed
setting can be dangerou& if you think the
engine-governed high speed needs
adjusting, contact your nearest authorzed
service center, which has proper
equipment and experience to make any
necessary adjustments.
Tubular frame
Sewn
hem
Sewn hem
Fli_ !_d
Lower frame
i
Tubular frame
Lower frame handle
(Frames
must be
fully
seated)
15