Deltaco 1902435 Manual Del Usuario página 7

ENG
Thank you for choosing DELTACO!
1. LED indicator (battery status)
2. Touch button for LED indicator
3. 2x USB-C ports (20W to 60W out, max
18W in)
USE
You can either use this device as a wall
charger or power bank. For wall charger,
connect it to the wall mains socket.
For use as a power bank, charge it first
and then disconnect it from the wall
mains socket.
See figure for placement of button.
Press the touch button to see remaining
charge, 1 to 4 lights will turn on. And to
start charging when it is being used as a
power bank.
1. Connect it to a wall mains power socket.
Fully charged = All 4 LED indicators will
turn on.
2. Connect your devices with USB cables
(not included).
3. When your devices are fully charged,
disconnect them and the cables.
It will automatically turn off after 10
seconds of inactivity.
Note: If you use a USB-C to Lightning
cable, the LEDs will keep being lit. Discon-
nect the cable to turn off the LEDs.
Passthrough charging
When this device is connected to a
power supply and it is charging a device
at the same time, it will make sure your
device is charged as fast as possible. Any
remaining power will be stored internally
for power bank function.
LED STATUS
LED status (charging)
All LEDs are lit = fully charged
One of the LEDs are flashing = Charging,
0-25% (LED 1), 26-50% (LED 2), 51-75%
(LED 3), 76-100% (LED 4).
LED status (discharging)
When the device is being used as power
bank and charging other devices, i.e.,
discharging.
1 to 4 LEDs are lit = remaining charge,
0-25% (1 LED is lit), 26-50% (2 LEDs are
lit), 51-75% (3 LEDs are lit), 76-100% (4
LEDs are lit).
LED 1 is flashing = low battery.
When the battery is very low, this device
will automatically power off to protect the
internal batteries.
Protections & troubleshooting
Overheat protection
If the battery's temperature reaches over
50°C this device will automatically power
off to protect the internal batteries.
When it has cooled down to 45°C it will
automatically power on again.
Discharge protection
If the battery's temperature reaches over
60°C this device will automatically stop
charging other devices to protect the in-
ternal batteries, and it will flash all 4 LEDs.
When it has cooled down to 54°C it will
automatically start charging again.
Over discharge protection
If the battery is exhausted this device will
automatically stop charging other devices
to protect the internal batteries. Remove
all the cables and/or unplug it from the
wall mains and reconnect the cables and
plug to the wall mains again. It will start
charging again.
7