Publicidad
FR - Installation facultative de coin
Alignez et placez l'une des cales horizontales ou verticales sur le support de
montage en fonction du sens vers lequel la sonnette sera orientée. Pour changer l'angle d'orientation,
retournez le support horizontal ou vertical.
ES - Instalación de cuña opcional
Alinee y coloque el soporte horizontal o el vertical en el soporte de montaje según la dirección hacia
la que desea que apunte el timbre. Para cambiar la orientación del ángulo, voltee el soporte horizontal
o el vertical hacia abajo.
EN - Doorbell Setup
1.
Remove your existing doorbell and disconnect the wiring.
Tip:
Bend the power cables so they do not fall through the wall.
2.
(Optional)
Install the Wedges. Make sure the Wedge and Mounting
Bracket align.
3.
Place the Mounting Bracket on the desired location with the
arrow pointing up.
4.
Mark the holes for screws.
5.
Using a Phillips-head screwdriver and the provided screws, secure
the Mounting Bracket to the surface.
Optional:
If you are mounting your camera into drywall, use the
provided drill 1/4" (6 mm) to drill holes where marked. Then use
the provided anchors and screws.
6.
Completely remove the power port terminal screws with a Philips-
head screwdriver.
7.
Thread the screws through the metal loops of the Connecting
Wires, and then tighten the screws clockwise.
Screw Hole
Screw Hole
Publicidad
