Haier HRT02WNC Manual Del Usuario página 6

1. Remove all packaging material. This includes the foam base and all adhesive
tape holding the refrigerated cooler accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before
powering on the refrigerated cooler.
P_ope_ A_ Ci_¢o_tio_
" To assure your refrigerated cooler works at the maximum efficiency it was
designed for, you should install if in a location where there is proper air
circulation, plumbing and electrical connections.
The following are recommended clearances around the refrigerated cooler:
Sides ............... 2 "(50ram)
Top .................... 2" (50mm)
Back .................. 4" (100mm)
IIIE_e@_c_ _equ_e_e_ts
" Make sure there is a suitable power Outlet (1 !5 volts, 15 amps outlet) with
proper grounding to power the refrigerated cooler.
" Avoid the use of three plug adapters or cutting off the third grounding in order
to accommodate a two plug outlet. This is a dangerous practice since it
provides no effective grounding for the refrigerated cooler and may result in
shod< hazard.