Descargar Imprimir esta página

Bosch SGV45E03UC Manual De Uso Y Cuidado página 12

Ocultar thumbs Ver también para SGV45E03UC:

Publicidad

Idiomas disponibles

Idiomas disponibles

Figure 19
Hidden Top Controls
I1) Open the door I
4) Close the
I
door to start I
!
Delay Start
This option allows you to delay the start time of your dishwasher.
To activate:
Turn the dishwasher on.
Select the desired wash cycle.
Press and hold the Delay Start button. Release when the desired delay time is shown in
the display window.
The Cycle Completion
Signal
This Cycle Completion Signal is a tone that sounds to alert you when your dishwasher
finishes washing and drying your dishes. You can either disable the tone or set the volume.
To activate:
Press and hold the right "Cancel Drain" button then press and hold the On/Off button.
When the light on the "Cancel Drain" button you are pressing illuminates and the tone
begins to sound, release both buttons.
Press the right-most "Cancel Drain" button until the tone is either at the desired volume
or is silent.
Press the On/Off Button. The Cycle Completion Signal is now set.
OPTIDRY
TM
This feature senses when the unit is low on rinse agent and automatically increases the
drying time. For best performance, always use a liquid rinse agent even if your detergent
contains a drying additive.
Starting
the Dishwasher
To start the dishwasher, follow the instructions
in Figure 19.
Interrupting
a Cycle
NOTE.: Should you need to interrupt a cycle (to add or remove an item, to add detergent,
etc.), it is best to do so within the first 30 minutes of the cycle.
Hidden Top Controls (See Figure 19)
1. Open the dishwasher door just far enough to expose the control panel.
2. Pressthe On/Off button to turn the unit off.
3. Wait at least ten seconds or until the water noises stop before opening the dishwasher
door.
4. To resume the cycle, press the On/Off button and close the dishwasher door.
,WARNING
You could
be seriously
scalded
if you allow
hot water
to splash
out of the dishwasher.
OPEN THE DOOR CAREFULLY
during
any wash
or rinse
cycle.
Do not fully
open
the door
until
water
noises
have stopped.
Figure 20
@O@
• _Cancel
Drain_
• %
Wait at least ten seconds or until water noises stop before opening the dishwasher door. To
resume the cycle, press the On/Off button and shut the dishwasher door.
Canceling
or Changing
a Cycle
To cancel or change a cycle, open the dishwasher door far enough to expose the control
buttons then press and hold for three seconds the two buttons labeled "Cancel Drain" as
shown in Figure 20.
Close the door and wait until the dishwasher completes the cycle (approximately
1 minute).
Open the door and press the ON/OFF button.
You may now begin a new cycle.
12

Publicidad

loading