Descargar Imprimir esta página

Craftsman 917.378430 Manual Del Usuario página 14

Publicidad

Idiomas disponibles

Idiomas disponibles

TO REMOVE/REPLACE
DRIVE BELT
1. Remove drive cover.
Remove belt
• from gearcase pulley by pushing
down on pulley and roiling belt off it.
2. Turn lawn mower on its side with air
filter and carburetor up.
3. Remove blade.
4. Remove debris shield•
5. Remove belt from engine pulley on
crankshaft.
6. Install new belt by reversing above
steps.
7. Always use factory approved belt to
assure fit and long life.
Drive
NOTE: if vinyl bindings are too stiff, hold
them in warm water for a few minutes. If
bag gets wet, let it dry before using.
_CAUTION:
Do not run your lawn
mower without clipping deflector or
approved grass catcher in place. Never
attempt to operate the lawn mower with
the rear door removed or propped open.
Catcher
BeLt
Push
down
TO ADJUST HANDLE
The upper handle may be adjusted to
four (4) different height positions.
1. Loosen both handle knobs only
enough to allow the upper handle to
pivot to the desired adjustment
position•
2. Tighten both handle knobs securely.
Handle Knob
Handle Knob
TO ASSEMBLE
GRASS CATCHER
1, Put grass catcher frame into grass bag
with rigid part of bag on the bottom.
Make sure the frame handle is outside
of the bag top.
2, Slip vinyl bindings over frame.
_t
Frame
opening
ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that the engine is running too fast
or too slow, take your lawn mower to a
Sears or other qualified service center for
repair and adjustment.
CARBURETOR
Your carburetor has a non-adjustable
fixed main jet for mixture control• If your
engine does not operate properly due to
suspected
carburetor problems, take
your lawn mower to a Sears or other
qualified service
center
for repair and/or
adjustment.
IMPORTANT:
Never tamper with the
engine governor, which is factory set for
proper engine speed,
Overspeeding
the
engine above the factory high speed
setting can be dangerous.
If you think the
engine-governed
high speed needs
adjusting, contact a Sears or other
qualified service
center, which has
proper equipment and experience to
make any necessary adjustments•
14

Publicidad

loading