Publicidad
Idiomas disponibles
Idiomas disponibles
The
operation of any lawn
mower can result in
foreign objects thrown into
the eyes, which can result
in severe eye damage.
Always wear safety glasses or eye
shields while operating your lawn mower
or performing any adjustments
or repairs.
We recommend a wide vision safety
mask over spectacles or standard safety
glasses.
HOWTO
USEYOUR
LAWN MOWER
ENGINE SPEED
The engine speed was set at the factory
for optimum performance. Speed is not
adjustable.
ENGINE ZONE CONTROL
_iLCAUTION:
Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the dsk
of blade contact injury. Do not under any
circumstances attempt to defeat the
function of the operator control. The blade
turns when the engine is running,
• Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
TO ADJUST CU'FrlNG HEIGHT
Raise wheels for low cut and lower
wheels for high cut, adjust cutting height
to suit your requirements. Medium
position is best for most lawns.
To change cutting height, squeeze
adjuster lever toward wheel. Move
wheel up or down to suit your require-
ments. Be sure all wheels are in the
same setting.
NOTE: Adjuster is properly positioned
when plate tab inserts into hole in lever.
Also, 9-position adjusters (if so equipped)
allow lever to be positioned between the
plate tabs.
Plate Tab
LowerWheels for High Cut
/
_,dlk
(._
Lever
Raise Wheets for Low Cut
TO CONVERT MOWER
Yourlawn mower was shipped ready to be
used as a mulcher. To convertto bagging :
REAR BAGGING
• Liftrear door of the iawn mower and place
the grasscatcher frame hooks ontothe
door pivot pins.
• To convert to mulchingoperation, remove
grasscatcher and close rear door.
_CAUTION:
Do not run your lawn mower
without clipping deflector or approved
grass catcher in place. Never attempt to
operate the lawn mower with the rear
door removed or propped open,
Pivot
Grass catcher
handle
Catcher
TO EMPTY GRASS CATCHER
1. Open door and lift up on grass catcher
using the frame handle,
2. Remove grass catcher with clippings
from under lawn mower handle.
3. Empty clippings from bag using both
frame handle and bag handle.
NOTE: Do not drag the bag when
emptying; it will cause unnecessary wear.
/
Bag
ca_herframe
handle
handle
Publicidad
