Descargar Imprimir esta página

Craftsman 917.378430 Manual Del Usuario página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

CYLINDER
1. Remove spark plug.
2.. Pour one ounce (29 ml) of oil through
spark plug hole into cylinder.
3. Pull starter handle slowly a few times
to distribute oil.
4. Replace with new spark plug.
BAI-FERY
Disconnect the battery from the engine
connector and charge battery 48 hours.
OTHER
• Do not store gasoline from one season
to another.
• Replace your gasoline can if your can
starts to rust, Rust and/or dirt in your
gasoline will cause problems.
• If possible, store your unit indoors and
cover it to give protection from dust and
dirt.
• Cover your unit with a suitable protec-
tive cover that does not retain mois-
ture. Do not use plastic. Plastic cannot
breathe which allows condensation to
form and will cause your unit to rust.
IMPORTANT:
Never cover mower while
engone and exhaust areas are still warm.
CAUTION:Never
store the lawn mower
with gasoline in the tank inside a building
where fumes may reach an open flame or
spark. Allow the engine to cool before
storing in any enclosure.
TROUBLESHOOTING
CHART
PROBLEM
CAUSE
Does not start
1, Dirty air filter.
2, Out of fuel.
3, Stale fuel,
4, Water in fuel.
5, Spark plug wire is
disconnected.
6. Bad spark plug.
7. Loose blade or broken
blade adapter.
8. Control bar in released
position,
9, Control bar defective,
10.Weak Battery
11. Disconnected
battery
connector.
CORRECTION
1. Clean/replace air filter.
2. Fill fuel tank.
3. Drain tank and refill with
fresh clean fuel.
4. Drain fuel tank and
carburetor and refill tank
with fresh gasoline.
5. Connect wire to plug.
6. Replace spark plug.
7. Tighten blade bolt or
replace blade adapter.
8. Depress control bar to
handle.
9. Replace control bar.
10.Charge
battery.
11.Connect battery to engine.
16

Publicidad

loading