GE AEL24 Serie Manual Del Propietario Y Instrucciones De Instalación página 4

About the controls on the air conditioner
Features and appearance will vary.
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
NOTE: The display always showstile room
temperature exceptwhen setting tile Set
temperature or the Delaytimer.
Light indicates the unit
is in the temperature or
delay time Set mode.
=
Light indicates tile delay
timer is set.
Air Conditioner Controls
Delay 1-24hr
Delaytimer __/_ li__ Delaytimer
Decrease Increase
Mode select Auto Fan
oil
Failspeed Fan speed
Decrease Increase
Temperature 0 _ @ Unit power
set increase on/off
and Decrease
Remote Control
Controls
Power Pad 0
Turns air conditioner on and off. When turned
on, the display will show the room temperature.
Display
Shows the room temperature or time remaining
on the Delay timer. Shows the Set temperature
while setting the temperature in Cool or Energy
Saver modes. The Set light will turn on while
setting.
O emp Increase A/Decrease T Pads
Use to set temperature when in Cool or Energy
Saver mode. The Set light will turn on while
setting.
Delay Timer Increase A (+)/Decrease T (-)
Pads
Each touch of the Increase A / Decrease T
pads on the unit or the Increase + / Decrease
- pads on the remote control will set the delay
time when using the Delay ./.-24hr timer. The
Set light will turn on while setting.
O an Speed Pads
Use to set the fan speed to Low, Mad, High
orAuto on the unit. NOTE: On the remote
control, use the fan speed Increase + /
Decrease - pads to set the fan speeds to Low,
Mad or High. Use the Auto pad to turn Auto
fan on.
@
Mode Pad
Use to set the air conditioner to Cool, Energy
Sever or Fun Only mode.
Delay Pads
Delay ON--When the air conditioner is off, it can
be set to automatically come on in i to 24 hours
at its previous mode and fan settings.
Delay OFF--When the air conditioner is on,
it can be set to automatically turn off in i to
24 hours.
How to set:
Pressthe Delay 1-24hr pad on the unit or on the
remote control. Eachtouch of the Increase A
/ DecreuseTpads on the unit or the Increase
+ / Decrease - pads on the remote control will
set the timer in 1-hour intervals. The Set light will
turn on while setting.
To review the remaining time on the Delay
1-24hr timer, press the Delay 1-24hr pad on the
unit or on the remote control. Use the Increase
A / Decrease T pads on the unit or the
Increase + / Decrease - pads on the remote
control to set a new time if desired.
To cancel the timer, press the Delay 1-24hr pad
until the light on the Delay 1-24hr pad goes off.
Note: The default temperature reading on the display is degree Fahrenheit (°F). To change the display to
degree Celcius (°C),press the Temp Increase A and Temp Decrease T buttons together and hold for 3
seconds. Repeat the process to change back to degree Fahrenheit (°F)
4