airhood AH-01BG Manual Del Usuario página 4

■ The built-in battery must only be replaced by a qualified service provider using the exact
same or equivalent type battery. Incorrect battery installation could lead to an explosion.
■ Keep the unit in a temperate climate. High temperatures can damage the AirHood's
performance and reduce the battery's lifespan. Exposure to low temperatures and then
warmer temperatures can cause condensation inside the unit that may damage the
electronic circuits.
■ Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting
of a battery, can result in an explosion.
■ Danger of explosion! A battery subjected to extremely low air pressure, extremely high
temperatures or intense heat sources such as direct sunlight or naked flames may result
in an explosion or leakage of flammable liquid or gas.
■ High or low extreme temperatures that a battery can be subjected to during use,
storage or transportation:
– during use: -10°C to 40°C / 14°F to 104°F
– storage: -10°C to 40°C / 14°F to 104°F
– transportation: -10°C to 40°C / 14°F to 104°F
■ Do not charge the battery longer than specified as this can reduce the battery's lifespan.
Charge the battery fully when using the unit for the first time.
■ Charge the battery at least once a month, even if you are not using it, to protect the
battery and ensure its longevity.
■ In the event of a leak, immediately contact the wholesaler, retail outlet or service centre
for assistance. If the battery acid has leaked, avoid any contact with the skin, eyes, and
mucous membranes. Should you accidentally come into contact with the battery acid,
rinse the affected area and contact a doctor.
■ To prevent the battery from overheating:
– When the room temperature ambient temperature reaches 65°C, the protection
will be activated. All device functions will turn off (light, fan, charging circuit).
– When the ambient temperature drops to about 60°C, the functions will not be restored
immediately. The user needs to perform operations to restore the device's function.
– When the function is available, all battery indicator lights will turn on until the user
resets the device.
– To initiate the reset the user will have to slide the switch to "O" level. If it is already
on "O" level, then it needs to slide to another level and return to "O" so that the PCB
can receive the signal.
READ AND SAVE THESE INSTRUCTIONS
4 | EN | Airhood (AH-01BG / AH-01BU)