Publicidad
Idiomas disponibles
Idiomas disponibles
_
WARNING:
Before using any attachment, read and
!
understand the manual that came with the attachment.
J
Follow all safety information contained within.
h_J
WARNING:
T° avoid serious personal injury and
j
damage to the unit, shut the unit off before removing or
installing an attachment.
OPERATING
THE COUPLER
The coupler enables the use of various optional attachments.
Installing
the Attachment
1. Remove the hanger cap from the attachment.
Keep the hanger
cap for use when storing the attachment.
If present, remove the
gray spacer from the coupler.
2. Set the unit on a flat, level surface.
3. Turn the knob counterclockwise
to loosen the coupler (Fig. 3).
4. Align the release button with the guide recess (Fig. 4).
5. Push the attachment
straight into the coupler until the release
button snaps firmly into the primary hole (Fig. 4).
6. Turn the knob clockwise to tighten the coupler (Fig. 3).
NOTE: Do not tighten the nut (Fig. 4).
i, 1 c ,o,,o°
e,o eo e atn theunt
a esu ethe
!
release button is fully snapped into the primary hole and
the knob is securely tightened.
_
CAUTION:
The release button should be snapped into
i
the primary hole only. Using the wrong hole could lead to
J
personal injury or damage to the unit.
Removing
the Attachment
1. Set the unit on a flat, level surface.
2. Turn the knob counterclockwise
to loosen the coupler (Fig. 3).
3. Press and hold the release button (Fig. 4).
4. Pull the attachment
straight out of the coupler (Fig. 2).
Coupler
Attachment
Fig. 2
Tighte
Knob
Fig. 3
Primary Hole
Release Button
Nut
Guide Recess
Fig. 4
Publicidad
