GE GXCF15HWW Manual Del Propietário página 4

Using the water dispenser.
Features and Parts List
0 BottleSupport C ollar--White (WS28X10049)
Separator (WS28X10013)
ColdWater Tank
Hot(Red)and Cold(Blue)Power Switch (backofdispenser).
Tile Cold (Blue) power switch also turns on tile chiller
c()mpartn_ent
(modelGXCF25HWW only).
IndicatorLights. T he green light will be lit when the dispenser is
plugged in. The red and blue lights will o'cle on and off while
the dispenser heats and cools the water. Compressor start is
delayed up to 3 minutes,
Hot _ , RoomTemperature i, Cold U WaterDispenserButtons
Dispenser Drip Tray (WS28X10026) and Grille (WS28X10027)
Compartment Drip Tray(WS29X10029) (modelGXCF25HWW only)
StorageCompartment (modelGXCF15HWW only). D o not use to store
food requiring refrigeration. The compartment is not
reflJgerated.
ChillerCompartment (modelGXCF25HWW only). T he
compartment
is intended solely fin" use in chilling canned and boxed beverages,
and packaged nonperishables.
Compartment Shelf(WS28X100281
DrainageCap(WSOlXIO008)
0 SiliconStopper (WSOIXIO007)
Loading the Dispenser and Start Up
Sanitizethedispenser water tankspriorto
installing a full bottle ofwater for thefirsttime
(see "Cleaning andSanitizingthe Water Tanks").
IMPORTANT'. Make sure the dispenseris unplugged
with both the hot and coldpower switches (onthe
back of the dispenser)set to the O(off)position.
Before placing the water bottle on the dispenser,
wash handsand wipe the top of the bottle with a
clean cloth.Avoid touching the part of the bottle
that will be in contact with the water dispense_
Make sure the water level in the top of the
dispenseris low enoughto allow for proper
bottle installation.Failureto do so may cause
the dispenser to overflow,
1. Peel tile label fl'om tile top cover of the
bottle (if present). Do not rem(>ve the entire
bottle
cap.
2. Place tile bottle on top of the dispenser as
showll,
aligning tile dispensing x:dve probe
to the center (ff the water bottle cap. Press
down mltil tile probe penetrates tile bottle
cap, allowing tile bottle t(> rest (>n tile
support collar:
3. IMPORTANT'.Press both dispense buttons until
water runs from both taps.
4. Plug ill tile dispensel:
5. Set the COI,D and HOT power switches
(located on tile top leit rear oI tile dispenser)
to the I (on) position.
6. _Mlow 30 minutes fiw water to reach hot and
cold temperatures.
Contact a local water bottle distributor to purchase
water bottles.
4