Publicidad
Idiomas disponibles
Idiomas disponibles
Careand cleaning of the dispenser.
(rear of dispenser)
Drain
outlet cap
Draining the Dispenser
Thedispensershouldbe drained before cleaning
the tanksand beforeleavingfor long vacationsor
absences.
1. Set both
power
switches
(oil tile back of
tile dispenser)
in tile 0 (off)position
and
unplug
tile dispenser.
2. Remove
tile water
bottle
fl'om
tile
dispenser.
3. Put a container
that will withstand
hot
water
under
tile hot water
tap. Press
the
hot dispenser
button
until the water is cool
(about
1 quart).
Add water
to the cold
water
reservoir
(on top where
the bottle
sui)plies
water)
as needed.
4. Dispense
water fl'om both
buttons
into
container(s)
until no more
water
can be
dispensed
(about
1 quart
of water still
remains
in tile dispenser).
5. Place
a large
bucket
beneath
the drain
outlet
on tile rear of tile dispenser.
6. Using
a Phillips
screwdriver;
loosen
tile
screws on the bracket
covering
the drain
outlet
cap. Rotate
tile bracket
out of tile
way to allow access
to tile cap.
7. Remove
tile cap and silicon
Stol)per
fl'om
tile drain
outlet
and
and allow water
to
drain. After
draining,
replace the stopper
and cap.
8. Rotate
tile bracket
back into
place
and
tighten
screws.
Make sure
to install
a flfll bottle
and
dispense
water fl'om
tile hot water
tap beflwe
I)lugging
in and
turning
on tile dispenser
(see Loading the Dispenser).
Toremove
Support
collar
To replace
N Separator
Cleaning the Separator
IMPORTANT'. Set both power switches (on the
back of the dispenser) in the 0 (oft) position and
unplug the water dispenser before cleaning.
1. Remove
tile water
bottle
and
drain
tile
dispenser
(see Draining the Dispenser).
2. Remove
tile support
collar
by turning
counterclockwise
and
pulling
straight
ott.
3. Remove
tile plastic
separator
by pulling
straight
out (you may need
to twist slightly
to loosen).
4. Clean
tile separator
with dish soap and
water
or in the top rack of the dishwasher.
5. D_w tile separator
thoroughly
on both
sides.
6. Using
a clean
cloth
or paper
towel,
thoroughly
dry tile cold water reservoir.
7. Place
tile separator
back in tile dispenser.
Make sure
tile long,
tapered
end
of tile
separator
is positioned
firmly
on tile metal
plug on tile bottom
of tile reservoir.
8. Replace
the sui)port
collar
and
turn
clockwise
until it is firmly
in place.
9. Install
a hill water
bottle
on the dispenser
(see Loading the Dispenser).
Publicidad
