Publicidad
Idiomas disponibles
Idiomas disponibles
RECHARGEABLE
BATTERY
CHARGING
BATTERY
The
battery
pack
is not fully
charged
at the
factory.
Before
attempting
to charge
the battery
pack, thoroughly
read all Safety
instructions.
The charger
is designed
to use standard
household
120 volt 60 Hz power.
1.
Plug cord from charger
into charger
base. (See Figure 2)
Figure 2 - Plug Charger into Base
2.
3.
Plug the charger
into any standard
120 Volt 60 Hz electrical
outlet.
IMPORTANT: Do not charge by means
of an engine generator
or DC power
source. Use only 120V AC.
Slide the charger onto the battery pack
as shown in Figure 3. The LED will
light up, Let the battery pack charge
until red LED turns off. At'ter the ini-
tial charge, under normal usage, your
battery pack should be fully charged in
3 to 9 hours.
4.
Unplug charger.
Remove the charger
by sliding off (See Figure 4).
5.
Place the battery pack in the tool and be
certain that it is inserted tully into the
tool cavity until it "clicks" into place.
Figure 4 - Remove Charger
iMPORTANT
CHARGING
NOTES
1.
After
normal
usage,
your
battery
pack should be tully charged in 3 to 9
hours. If the battery pack is run-down
completely,
it may take up to 9 hours
to become tully charged. Your battery
pack was sent from the factory in an
uncharged
condition.
For best perfor-
mance charge
battery until red LED
turns off. Allow the battery
to cool
down 30 minutes before charging after
using the saw. NOTE: A hot battery
placed in the charger will not charge.
2.
DO NOT charge the battery pack in an
air temperature
below 40°F (4,5 °C) or
above 105°F (40,5 °C). This is impor-
tant and will prevent serious damage to
the battery pack. Longest life and best
performance
can be obtained if battery
pack is charged when air temperature
is about 75°F (24°C).
3.
While charging, the charger may hum
and become warm to touch. This is a
normal condition and does not indicate
a problem.
4.
If the battery
pack does not charge
properly
•
Check current at receptacle by plugging
in a lamp or other appliance.
•
Check to see if receptacle is connected
to a light switch which turns power off
when you turn out the lights.
•
Move charger
and battery
pack to a
surrounding
air temperature
of 40°F
(4,5°C) to 105°F (40,5 °C)
°
If the receptacle
and temperature
are
OK, and you do not get proper charg-
ing, call the Customer Selwice
Department.
5.
The battery pack should be recharged
when
it fails to produce
sufficient
power on jobs which were easily done
previously. DO NOT CONTINUE
us-
ing product with its battery pack in a
depleted condition.
6.
To prolong battery life, avoid leaving
the battery
pack on charger
for ex-
tended periods of time (over 30 days
without use). Although overcharging
is
not a safety concern, it can significantly
reduce overall battery life.
7.
The battery pack will reach optimum
performance
after being cycled 5 times
during normal usage. There is no need
to run the batteries down completely
before
recharging.
Normal
usage
is
the best method
of discharging
and
recharging
the batteries.
Figure 3 - Slid Charger onto
Battery
10
Publicidad
