Publicidad
Idiomas disponibles
Idiomas disponibles
• Repeat theabove procedure forthe
second c utting line onthelower s ection
ofthespool.
• Fitthespool o nto thetool a sdescribed
in"FITTING ANEW SPOOL OF
CUTTING L INE".
_CAUTION: Before y oubegin t rimming,
only use theappropriate
type ofcutting
line. E nsure that c utting l ine ispresent in
both sections ofthespool (figure 12).
2. Your trimmer linecandryoutover
time. T okeep your l ine intopcondition,
store spare pre-wound spools o r bulk
lineina plastic, sealable b agwith a
tablespoon ofwater.
3. Plastic p arts may becleaned b yusing
amild soap and a damp rag.
4.Theline cutter o ntheedge oftheguard
candull o ver t ime. I tisrecommended
youperiodically
touch-up the
sharpness oftheblade witha file.
Use Craftsman replacement
spool Model
No. 8 5942.
Reload nylon line (either bulk orprewound
replacement
spool) asdescribed inthis
manual.
• USE ONLY
.065 inch (1.65 mm)
DIAMETER NYLON MONOFILAMENT
LINE. Do not use serrated or heavier
gauge line, as they will overload the
motor and cause overheating. The unit
only functions properly with .065 inch
(1.65 mm) diameter nylon monofilament
line. This line is available at your local
Sears store or other Craftsman outlet.
_,WARNING:
The use of any accessory
not recommended
by Sears for use with
this tool could be hazardous.
IMPORTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance
and adjustment should be performed by a
Sears or other qualified service dealer,
always using identical replacement parts.
-4,WARNING: To avoid serious injury,
switch off and unplug the tool before
performing any maintenance.
1. Keep the air intake slots (figure 15)
clean to avoid overheating.
_t,WARNING: To avoid serious injury,
switch off and unplug the tool before
performing any maintenance.
Tool runs slowly
• Check that the cassette housing can
rotate freely. Carefully clean it if necessary.
• Check that the cutting line does not
protrude more than approximately 4-3/8
inches (111mm) from the cassette. If it
does, cut it off so that it just reaches the
line trimming blade.
Automatic
line feed does not work
• Keep the tabs depressed and remove
the cassette from the cassette housing
in the trimmer head.
• Pull the cutting line until it protrudes
approximately 4-3/8 inches (111mm)
from the cassette. If insufficient cutting
line is left on the spool, install a new
spool of cutting line.
• Align the tabs on the cassette with the
cut outs in the housing.
• Push the cassette onto the housing
until it snaps securely into place.
• If the cutting line protrudes beyond the
trimming blade, cut it off so that it just
reaches the blade.
Publicidad
