Snuza Hero MD Guía Rápida De Inicio página 5

Hero
Scan the QR
code for the full
instruction manual
For support contact us through support@snuza.com
1.1 Switch on by pressing the 'ON/OFF' button.
1.2 A start-up test will run, followed by the indication of the battery level
with 3 beeps.
1.3 You will hear a 2-tone beep with 2 flashing red LEDs, indicating that
calibration is required. Place on a flat, stationary surface to perform
calibration.
1.4 Wait for the start-up tone and green flash. The Hero
onto your baby's nappy/diaper for monitoring. Scan the QR code above to
watch the Calibration video.
2.1 Fold over the top edge of the nappy/diaper and ensure the Hero
snugly.
2.2 Attach the Hero
2.3 Ensure the silicone Breathing Sensor is in contact with your baby's tummy.
IMPORTANT: Ensure no skin pinching by gently sweeping
2.4
your fingers between the skin and clip.
3.1 When breathing is detected, the Breathing Indicator Light flashes
with each breath.
3.2 When no breathing is detected, the Alarm Indicator Light will flash red
every 3 seconds.
3.3 If no breathing is detected for 15 seconds, the Hero
with a red flashing Breathing Indicator Light.
Quick Start Guide
MD
1. Prepare
2. Attach
squarely to the folded edge of the nappy/diaper.
MD
3. Monitor
IMPORTANT: Scan the
QR code to watch
the Calibration video
is now ready to clip
MD
vibrates and beeps
MD
ENGLISH
MD fits