GE 18 Manual Del Propietario E Instalación página 21

mnstaiiation mnstructions
[] TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
For models with a base grille, remo_e it by ,grasI)ing, it
about 6" fl'om each end and Imllim"_ its bottom edge
toward veil.
Using a Torx _':driver; move the
bottom
hinge bracket
and plastic washer fl'om the right side to the left side,
NOTE: If the washer is not on the hinge bracket,
check to see if it is stuck to the bottom of the dora:
q
0_.[
Plasiic Washer
.4"-
For models with a base grille, before rel)lacino_ the
base grille, remoxe the grille cap b) remoxing the
screw, Screw the cap to the opposite side,
Replace the base grille by inserting the tops of the
metal clips into the o_;d vents, making sm'e one of the
plastic tabs on the back of the grille goes into each of
the oven vents. Then push the bottom of the grille
fi)rward until it snaps into place.
[] TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remo_e the center hinge bracket
by removing
the
three _' Torx sci ews.
NOTE: Keep these screws with the hinge bracket,
They are hmg screws and will be used when installing
the hinge on the other side,
On some models, you will need to remo',e the cole>
matched caps fl'om the screw heads before _ou can
remo_e the screws. Use the edge of a thin flat blade to
genfl) P_T the caps off the screw heads, (A put B' knife
works well for this,) Coxer the blade with tape to
prex ent scratching, the l)aim.
Remoxe the three Torx <_> s crews from the center left
side of the cabinet, Screw them into the holes on
the right side,
Place the center hinge bracket oxer the holes at
the center left side of the cabinet. Insert and
tighten the three hmg screws,
Replace the caps b) snapping them oxer the screws
with )our finger.
Screw Cap
[] TRANSFER DOOR STOPS
On each dora; moxe the metal door stop h'om the
right to the lelL
Moxe any screws from the left to the fight.
Door Sto
LeftSide RightSide
21