Publicidad
Idiomas disponibles
Idiomas disponibles
4. Pour measured liquid fabric softener into the fabric softener
dispenser, if desired.
5.
6.
•
Do not overfill. The dispenser holds 3 oz (94 mL), or a
standard capful of fabric softener.
•
The fabric softener is dispensed in the final rinse.
•
Do not spill or drip any fabric softener on the clothes.
•
Use only liquid fabric softener in this dispenser.
Close the washer lid.
Turn the Water Level selector to the correct setting for your
wash load and the type of fabric being washed.
•
Choose a water level that allows the load to move freely
for best fabric care.
•
You may change to a higher level setting after the washer
has started filling by turning the knob to a different
setting.
Medium
Load
Small
@
_
_ Large
Load
Load
Reset
7. Set the Water Temperature selector to the correct setting for
the type of fabric and soils being washed. Use the warmest
water safe for fabric. Follow garment label instructions.
Water Temp
Use for
Hot
Whites and pastels
Heavy soils
Warm
Bright colors
Moderate to light soils
Cold
Colors that bleed or fade
Light soils
NOTE: In wash water temperatures
colder than 60°F (15.6°C),
detergents do not dissolve well. Soils can be difficult to
remove. Some fabrics can retain wear wrinkles and have
increased pilling (the formation of small lint-like balls on the
surface of garments).
(OPTIONAL) An Automatic Temperature Control (ATC)
electronically
senses and maintains a uniform water
temperature by regulating incoming hot and cold water.
•
Even in cold wash, some warm water is let into the
washer to maintain a minimum temperature
of
approximately
60°F (15.6°C).
(OPTIONS) You can customize your wash by adding rinse
Options to your cycle selections. A cycle will "start" where
you set the Cycle Selector Control (Timer) knob. See
"Selecting a Cycle and Time." The cycle will "stop" where you
set the Options Control knob. This knob has settings for:
•
One Rinse. Use this option for one rinse after a basic
wash cycle, Rinse & Spin, and Drain & Spin.
•
2nd Rinse. A 2nd Rinse can be added to the Ultra Clean
cycle and to the Permanent Press II cycle.
•
Soak Only. Use this option for set-in stains and soil that
need extra time for removal.
•
Soak & Prewash. Select the prewash option to ensure
thorough cleaning of your heavily soiled and stained
loads.
NOTE: The Prewash cycle and Soak & Prewash Only option
should be followed by a main wash cycle with additional
detergent added. The Soak Only option should be followed
by a main wash cycle without additional detergent.
0Set
th So e sOontrok ili!
in the load. See "Selecting Wash/Spin Speeds."
10. Push in the Cycle Selector Control (Timer) knob and turn it
clockwise to the wash cycle you want. Reduce the wash time
when using a small load size setting. See "Selecting a Cycle
and Time."
Pull out the Cycle Selector Control (Timer) knob to start the
washer.
To stop or restart your washer
•
To stop the washer at any time, push in the Cycle Selector
Control (Timer) knob.
•
To restart the washer, close the lid (if open) and pull out
the Cycle Selector Control (Timer) knob.
13
Publicidad
