Publicidad
Idiomas disponibles
Idiomas disponibles
WASHER CARE
Cleaning
the exterior
Use a soft, damp cloth or sponge to wipe up any spills such as
detergent or bleach. Occasionally
wipe the outside of your
washer to keep it looking new.
Cleaning
the interior
To clean your washer interior, add 1 cup (250 mL) of chlorine
bleach and 1 scoop or capful of detergent into your dispenser,
and run the washer through any cycle using hot water. Repeat
this process if necessary.
NOTE: Remove any hard water deposits using only cleaners
labeled as washer safe,
Fabric
softener and liquid chlorine bleach dispensers
Remove the cover that houses both the fabric softener and liquid
chlorine bleach dispensers. Use a soft cloth with a mild detergent
and warm water to clean the interior of both dispensers and the
inside surfaces of the cover. Reinstall the cover before washing
your next load.
::\
\\
Replace inlet hoses after five years of use to reduce the risk of
hose failure. Periodically inspect and replace inlet hoses if
bulges, kinks, cuts, wear or leaks are found.
When replacing your inlet hoses, mark the date of replacement
on the label with a permanent marker.
Install and store your washer where it will not freeze. Because
some water may stay in the hoses, freezing can damage your
washer. If storing or moving your washer during freezing weather,
winterize it.
Non-use
or vacation
care:
Operate your washer only when you are at home, If you will be on
vacation or not using your washer for an extended period of time,
you should:
•
Unplug washer or disconnect
power.
•
Turn off the water supply to the washer. This helps avoid
accidental flooding (due to a water pressure surge) while you
are away.
To winterize
washer:
1. Shut off both water faucets.
2. Disconnect
and drain water inlet hoses.
3. Put 1 qt (1 L) of R,V.-type antifreeze in the basket.
4. Run washer on a Spin cycle.
5. Unplug washer or disconnect
power.
To use washer
again:
1. Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets,
Emectricat Shock Hazard
Plug into a grounded
3 prong outlet.
Do not remove ground
prong.
Do not use an adapter.
Do not use an extension
cord.
Faimure to follow these instructions
can result in death,
fire, or emectrica{ shock.
2. Plug in washer or reconnect power.
3. Run the washer through any cycle with 1/2the normal
recommended
amount of detergent to clean out the
antifreeze.
To transport
the washer:
1. Shut off both water faucets.
2. Disconnect
and drain water inlet hoses,
3. If washer will be moved during freezing weather, put in 1 qt
(1 L) of R.V,-type antifreeze in the basket. Run washer on a
Spin cycle.
4. Disconnect
the drain from the drain system.
5. Unplug the power cord,
6. Place the inlet hoses into the basket.
7. Drape the power cord and drain hose over edge into the
basket.
8. Close the lid and put a piece of tape over the lid and down to
the front of the washer.
Reinstalling
the washer
1. Follow the "Installation
Instructions" to locate, level and
connect the washer.
2. Run the washer through any cycle with 1/2the normal
recommended
amount of detergent to clean out the
antifreeze, if used.
16
Publicidad
