Mounting The Inverter - Steca Elektronik StecaGrid 2020 Instrucciones De Instalación Y Manejo

8.2

Mounting the inverter

Fasten the mounting plate
1
Mounting the inverter on the mounting plate
744.711 | 12.20
Screw the mounting plate to the mounting surface using 4

screws:
Use screws (and dowels etc.) appropriate for the weight of
–
the inverter.
The mounting plate must lie flat on the mounting surface
–
and the metal strips at the sides must point forwards (Fig.
left).
Install the mounting plate vertically with the safety plate 
–
at the top (Fig. left).
Note
More information on determining the optimum position for the
mounting plate is provided in the attached information sheet.
The information sheet is also available at P. 148.
1. Grasp the inverter by the recesses , position it  in the mid-
1
dle of the mounting plate  and press lightly (Fig. left).
2. Lower the inverter into place :
2
The hooks on the rear side of the inverter slide over match-
–
ing protrusions on the mounting plate.
The retention plate on the mounting plate clicks audibly
3
–
into place.
3. The inverter must now sit securely on the mounting plate and
can no longer be slid upwards.
1
Note
The procedure for removing the inverter from the mounting plate
is described in 8.9, P. 24.
1
EN
19