Windgoo B3 Manual De Usuario página 6

Function Introduction:
1.charging: connect the charger to charge,with AC plug first and DC plug next.When
the power bar on bike handle shows full and the charger indicator turns green from
red, it indicates full power.
2.Press the power button: Push forward the power button to turn on the bike. The
dash board lights up after booting; Push back the power button to turn off the bike.
The dash board light will be off after turning off the power.
3. After booting, the dash board lights up and indicate the amount of electricity.
4.Horn.:Pressing the horn button, the horn sounds up.Recommend click it slightly.
When pressing for over 10 seconds, the horn stops, you need to repress it.
5. Front light：
front light.
6. Brake and rear light: Back light lights up when braking.It could not accelerate
before the brake is fully loosened.
7. Zero speed booting: you can accelerate with rotating the handle gently.
8. Speeding : Please speed up slowly,don't force the rotating bar hard or it will be
broken.
9. Cruise: Press the uniform cruise button when ride, then the bike runs at the same
speed. Press the button again and brake or release the rotating bar and speed up
again then the uniform cruise mode is canceled.
6