On-screen Menu Icons
Icon
Wireless signal strength
Night Vision Mode is enabled
Shows the camera that is currently presenting on the baby monitor screen
1
Note: This icon will not appear on the screen when there is only one camera
connected to the monitor.
Cycle Cameras enabled
Sound Alert enabled
Sound level of the room the camera is in
08:30 AM
Current time
Current battery level of the baby monitor
72 °F
Current operating temperature
NOTICE
Warning
Strangulation Hazard: Children have STRANGLED in cords. Keep this cord out of the reach of
children (more than 1m (3ft) away). Never use extension cords with AC Adapters. Only use the AC
Adapters provided.
This product complies with the radio interference requirements of the European
Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU. For the declaration of
conformity, visit the Web site: www.eufylife.com
This product can be used across EU member states.
Due to the used enclosure material, the product shall only be connected to a USB Interface of
version 2.0 or higher. The connection to so called power USB is prohibited.
The adapter shall be installed near the equipment and shall be easily accessible.
10 English
Icon Description
Do not use the Device in the environment at too high or too low temperature, never expose the
Device under strong sunshine or too wet environment.
The suitable temperature for T8321-M and accessories is -20°C-40°C
The suitable temperature for T8321-C and accessories is -20°C-40°C
When charging, please place the device in an environment that has a normal room temperature and
good ventilation.
It is recommended to charge the device in an environment with a temperature that ranges from
5°C~25°C.
Please ensure to use only the charger offered by the manufacturer. Using unauthorized charger may
cause danger and violate the authorization of the device and the guarantee article.
The charger output voltage / current is 5Vdc / 1A(for T8321-C) and 5Vdc / 2A (for T8321-M).The
plug considered as disconnect device of adapter.
If you use a third-party charger, the recommended output voltage / current of the adapter is 5Vdc /
1A (for T8321-C) and 5Vdc / 2A (for T8321-M),and the adapter shall be CE approval type.
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE
OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
RF exposure information: The Maximum Permissible Exposure (MPE) level has been calculated based
on a distance of d=20 cm between the device and the human body. To maintain compliance with RF
exposure requirement, use product that maintain a 20cm distance between the device and human
body.
Operating Frequency Range: 2410-2477MHz
The T8321-C Max Output Power: 19.12dBm(EIRP), The T8321-M Max Output Power: 19.56dBm
(EIRP) CE SAR:
This T8321-M was tested for typical body-worn operations with the back of the handset kept
0 mm from the body. The SAR limit of Europe is 4.0 W/kg. Device types T8321-M has also been
tested against this SAR limit. The highest SAR value reported under this standard during product
certification for use at the limb is 0.310W/kg . This device was tested for typical hand held
operations with the back of the device kept 0mm from the Limb.
The T8300-C device has been evaluated to meet general RF exposure requirements and can be
used in fixed exposure condition. RF exposure information: The Maximum Permissible Exposure
(MPE) level has been calculated based on a distance of d=20 cm between the device and the human
body. To maintain compliance with RF exposure requirement, use product that maintain a 20cm
distance between the device and human body.
Anker Innovations Deutschland GmbH | Georg-Muche-Strasse 3-5, 80807 Munich, Germany
Anker Technology (UK) Ltd | Suite B, Fairgate House, 205 Kings Road, Tyseley, Birmingham, B11 2AA,
United Kingdom
This product is designed and manufactured with high quality materials and components,
which can be recycled and reused.
English 11