ELECTRONIC CORDLESS TYING MACHINE
19. TROUBLE SHOOTING AND REPAIR
Problem
Possible reason
Battery is used up
The equipment
Battery not inserted
cannot be
correctly
started
On/off switch failure
Internal connecting line is
Intermittent
loose
running
On/off switch failure
After tying, it is loose and
not firm;
Unsuccessful tying due to
foreign material
Tying is not
successful,
Incorrect or missing wire
tying effect is
feeding
not good.
Tying is easily stuck by
branches.
The battery is not placed in
the charger correctly.
Cannot charge
The connection of charger
The red
and power supply is not
indicator of
correct.
charger is
Battery voltage is too low
blinking.
Battery failure
Charger failure
www.kamikazevolpi.com
Corrective measures
Charge
Check the correct insertion of the battery in
the tool
Send to the Service Centre for repair
Send to the Service Centre for repair
Adjust gear switch to a suitable level
Check if there are any foreign matters in
feeding track, clear up foreign matters and
unsuccessfully tied tying wire.
1. 1.Check if the tying wire is stuck in feeding
tray, if it is stuck, conduct cleaning timely.
2. 2.Check if there are any residual tying
wires or other foreign matters in the whole
feeding track, and conduct cleaning
timely.
Operation may be too fast, please adjust
operation speed. Only after confirming the
completion of tying action the tying machine
can be lifted up
Verify battery to charger connection
Verify correct connection of charger to
power supply
Wait for 10 minutes.
Replace battery
Replace battery charger
110
ELECTRONIC CORDLESS TYING MACHINE
20. CE DECLARATION OF CONFORMITY
www.kamikazevolpi.com
111