MSW -GH-ET-10000 Manual De Instrucciones página 40

3.2.
Preparation for operation
POSITIONING OF THE UNIT
The ambient temperature must not exceed 40°C and ambient humidity should not
exceed 85%. Place the unit in a way that ensures good air circulation. Make sure to
keep the minimum safe distance from each side of the device (see more in the
section "Safe use of the device"). Keep the unit away from any hot surfaces,
including direct sunlight. Always operate the unit on a level, stable, clean, fireproof
and dry surface and out of the reach of children and persons of impaired mental,
sensory and intellectual functions. Place the unit in such a way that the mains plug
can be reached at any time. Ensure that the power supply to the unit corresponds
to that specified on the identification plate!
ASSEMBLY OF THE UNIT
IMPORTANT: the unit requires a gas hose connection along with a regulator and a
cylinder - please contact your local gas supplier for more details.
First check the unit for any transport damage. Connect the power cord to
•
the power source.
Ground the unit.
•
Connect the gas tank to the device via the connection (D) - a pressure
•
regulator should be installed on the connection.
Open the gas valve of the tank and check for possible rupture/leaks - the
•
use of a special gas leak detection device is recommended.
NOTE: in the event of frequent, long-term use of the device at full power, frost may
form on the gas tank - this is normal. To prevent or reduce this effect, use a tank
with a larger capacity or connect 2 or more gas tanks simultaneously. Under no
circumstances should the tank itself be heated!
3.3.
Working with the device
3.3.1 Turning on
EN