cecotec BOLERO AGUAZERO 6500 C Manual De Instrucciones página 32

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Upper basket
2. Spray arms
3. Lower basket
Water softener
4.
5. Detergent dispenser
6. Rinse aid dispenser
7. Cutlery tray
Cup/mug tray
8.
9. Automatic door opening
Control panel. Fig. 2
Power icon
1.
2. Programme selection icon
3. ALT icon
4. Delay icon
Start/pause icon
5.
6. Programme indicator light
7. Rinse aid refill indicator light
8. Salt refill indicator light
3in1 indicator light
9.
10. Upper part washing indicator light
11. Auto Open indicator light
12. Bottom part washing indicator light
13. Digital display
Please note
The graphics in this manual are schematic representations and may not exactly match the
appliance.
2. BEFORE INSTALLATION
- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
62
Bolero Aguazero 6500 C/ Inox C/ Dark C
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
- Dishwasher
- Instruction manual
3. INSTALLATION
- Keep this instruction manual in a safe place for future reference. If you sell, give away or
move the appliance, make sure to keep this manual with the appliance, so that the new
owner can refer to it at any time.
- Please read this instruction manual carefully: it contains important information on the
safe installation, use and maintenance of the appliance.
- If it is necessary to move the appliance at any time, keep it in an upright position; if
absolutely necessary, it can be tilted on its back.
Positioning and levelling
Remove the device from its packaging and check that it has not been damaged during
1.
transport. If it is damaged, please contact the official Cecotec Technical Support Service
and do not continue with the installation process.
2. Check the dishwasher and position it so that its sides or rear panel are in contact with
adjacent cabinets or even the wall. This appliance can also be installed under a single
worktop.
3. Place the dishwasher on a level and sturdy floor. If the floor is uneven, the front legs of the
appliance can be adjusted until it reaches a horizontal position (the angle of inclination
should not exceed 2 degrees). If the appliance is correctly levelled, it will be more stable
and much less likely to move or cause vibration and noise during operation.
Connecting water and electricity supplies
- The connection of the water and electricity supplies must only be carried out by a qualified
technician.
- The dishwasher must not be placed on top of the water hoses or the power supply cable.
- The appliance must be connected to the water supply network by means of new pipes. Do
not use old hoses.
ENGLISH
63
Bolero Aguazero 6500 C/ Inox C/ Dark C