cecotec BOLERO AGUAZERO 6500 C Manual De Instrucciones página 42

ENGLISH
8. TROUBLESHOOTING
Error codes
When some faults occur, the appliance displays error codes to warn you. Contact the official
Cecotec Technical Support Service to solve the problem.
Code Problem Possible causes
E1 Door open Door opens while operating
E2 Water inlet Water inlet failure
E3 Water drainage Water drainage failure
E4 Temperature sensor Failure of the temperature sensor
E5 Overflow/leakage Overflow/leakage of water occurs
E6 Water leakage Water leakage occurs
E7 Heating element Abnormal heating
Warning!
If an overflow occurs, turn off the main water supply before contacting the Technical Support
Service. If there is water in the base tray due to an overflow or a small leak, you must remove
the water before restarting the dishwasher.
Spare parts availability
1. Seven years after the last model unit is sold: motor, circulation and drain pump, heaters
and heating elements including heat pumps (separately or in batches), piping and related
equipment including all hoses, valves, filters and AquaStop water leak detection system,
structural and door interior parts (separately or in batches), printed circuit boards, digital
displays, pressure switches, thermostats and sensors, software and firmware including
reset software.
2. Ten years after the last unit of the model was marketed: door hinge and seals, other seals,
spay arms, drainage filters, interior grilles, and plastic peripherals such as baskets and
lids.
Before calling technical support service
By reading the following pages you may find the solution to the problem or malfunction, which
may save you from having to contact the Technical Support Service.
82
Bolero Aguazero 6500 C/ Inox C/ Dark C
Problem Possible causes
Fuse has blown or
circuit breaker has been
tripped
The dishwasher
The power supply is
does not work
not on
Water pressure
is low
Drainage pump
does not stop Overflow
Some noises
are normal
Utensils are not secure
in the baskets or
Noise
something small has
fallen out of
a basket
Engine humming
There is foam Unsuitable detergent
inside the
dishwasher
Spilled rinse aid
The interior is Detergent with
stained colouring agent was
used
ENGLISH
Possible solution
Replace the fuse or reset the circuit breaker.
Remove any other device sharing the same
circuit as the dishwasher.
Make sure the dishwasher is on and door is
properly closed. Make sure that the power
cord is plugged into the socket properly.
Check that the water supply is connected
properly and that the water is turned on.
The system is designed to detect an
overflow. When you detect this, switch off
the circulation pump and switch on the drain
pump.
Sound of detergent dispenser opening.
Make sure that everything is securely
fastened in the dishwasher.
The dishwasher has not been used regularly.
If you do not use it often, remember to
schedule it to fill and empty every week, which
will help keep the gasket moist.
Use only detergent special for dishwashers
to prevent foam formation. If there is foam
forming, open the dishwasher and let it
evaporate. Add 4 litres of cold water in the
drum. Close and lock the dishwasher, then
start the pre-rinse wash cycle to drain the
water. Repeat the process if necessary.
Always clean spilled rinse aid immediately.
Make sure your detergent does not contain
colouring.
83
Bolero Aguazero 6500 C/ Inox C/ Dark C