]l.s,a,,a:,o
".s,ruc,,o.s
] ,,rCo.d,
J r_
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com
|
In Canada, call 1.800.561.3344or visit www.GEAppliances.ca
I
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
• IMPORTANT- Sove these i nstructions
for Iocol inspector's use.
•
IMPORTANT
--Observe
oil governing
codes ond ordinonces.
• Note to Installer-
Be sure to leove these
instructions
with the Consumer.
• Note to Consumer - Keep these instructions
for
future reference.
• Skill level-
Instollotion
of this opplionce
requires bosic mechonicol
skills.
• Completion time - Approximotely
1 hour
•
We recommend
thor two people instoll
this product.
•
Proper instollotion
is the responsibility
of the instoller.
•
Product foilure due to improper
instollotion
is not
covered under the Worronty.
• You MUST use ull supplied ports und use proper
instullotion
procedures
os described in these
instructions
when instolling this oir conditioner.
(_
ELECTRICAL REQUIREMENTS
(_
ome models require u 115/120-volt AC,
60-Hz grounded outlet protected with u
15-omp time-deloy fuse or circuit breoker.
The 3-prong grounding plug minimizes the
possibility of electric shock hozord. If the woll outlet you
plon to use is only o 2-prong outlet,
it is your responsibility to huve it reploced with
o properly grounded 3-prong wull outlet.
©
Some models require 230/208-volt
AC,
protected with o time-deloy fuse or circuit
breoker. These models should be instolled on
their own single bronch circuit for best
performonce ond to prevent overlooding
house or oportment
wiring circuits, which
could cuuse o possible fire hozord from
overheoting wires.
ACAUTION:
Do not, under any circumstances, cut or remove the
third (ground) prong from the power cord.
Do not change the plug on the power cord of this air
conditioner.
Aluminum house wiring may present special
problems--consult
a qualified electrician.
TOOLSYOU WILL NEED
Drill and 1/8" drill bit
Phillips head screwdriver
Pencil
Ruler or tape measure
Level
Scissors or knife
Power cord includes o current interrupter
device. A test ond reset button is provided on the
plug cuse. The device should be tested on u periodic
bosis by first pressing the TEST button ond then the
RESETbutton while plugged into the outlet. If the
TEST button does not trip or if the RESETbutton will not
stoy engoged, discontinue use of the oir conditioner
ond contoct o quolified service technicion.
6