muvit io MIOGAT001 Manual De Instrucciones página 35

Next, select the Gateway in the "Devices" tab, click on
"Add device", "Existing device", select the lockbox and
click on "Confirm". The box is now connected to the
Internet via the Gateway.
Note: Despite connecting via Bluetooth, the device will connect to
the router's Wi-Fi network, allowing you to control the equipment
from anywhere at any time. If the new device detected screen does
not appear, close the application completely, open it again and
repeat the above installation steps.
Connection via AP Mode:
Turn on the Gateway and press and hold the button for 6
seconds. Make sure the red LED light is on and the blue
LED light is flashing.
Activate the Phone Location. Once the application
is open, press "+" and then "Add device". Select the
purchased product to enter the installation wizard.
Check that the LED is slowly flashing blue, if not, follow
the instructions in the App to reset it, tick the "Slowly
flashing" tick and press "Next". Enter the password of
the Wi-Fi network, press "Next", then the application will
ask you to connect via Wi-Fi to the network "SmartLife-
XXXX", to do this click on "Connect", select the network
indicated above, press "Back" and follow the instructions
of the application to complete the installation.
6
English