Publicidad
Idiomas disponibles
Idiomas disponibles
CHARACTERISTICS
ES
▶Power: 80W
▶Speeds: 3 levels
▶Fixed or oscillating position
PT
▶Safety grille
▶Blade diameter: 50cm
▶Manual ignition
EN
▶Maximum air flow 4.800m3/h
▶220-240V~ 50Hz
FAN PARTS
FR
Grille
Blades
INSTALLATION
TOOLS NEEDED
• Pliers head screwdriver
• Flathead screwdriver
• Spanner
STEPS TO FOLLOW
1. Remove all spare parts from the box; all screws are
already pre-installed.
2. Place the fan base on a level surface.
3. Use the spanner to loosen the locking collar on the support
post. Slowly pull out the upper support post to adjust the fan
height. Make sure the support post is fully extended.
Instruction manual
Fixing screws
Inside tube
Screws
Grille
Outside tube
Base fixing
4. Assemble the entire support post to the base. Align the
holes and use the screws supplied with the base to secure
the support post in place.
5. Mount the motor assembly to the upper support post
connector. Ensure that the holes are aligned correctly.
6. Secure the motor assembly using a pivot bolt and nut or
bolts provided. Tighten the nut and bolt securely using the
adjustable spanner.
7. Slide the rear fan guard over the motor assembly and
secure it in place using the provided flange bolts (motor
bolts). Tighten the screws securely with the spanner.
8. Use the spanner to loosen the set screw on the back of
the fan blade assembly. Slide the fan blade assembly onto
the motor shaft.
9. Tighten the set screw on the back of the fan blade
assembly using the spanner on the flat surface of the fan
shaft.
10. Attach the front fan guard to the rear fan guard and
Motor
secure with the fasteners on the rear fan guard.
OPERATION
▶Using the 3-speed system you can start the fan, this system is
designed to give you maximum flexibility.
• POSITION 0: OFF position, no button pressed.
• POSITION 1: first speed
• POSITION 2: second speed
• POSITION 3: third speed
Base
IMPORTANT NOTES
▶Place the fan on a flat, dry surface.
▶Before connecting the device to the mains, make sure that the
switch is in the "0" position.
▶Plug the power cord into the mains socket 220-240V~ 50/60Hz.
▶If you do not use the ventilator for a long time, unplug the power
cord from the socket.
▶Never attempt to disassemble the device where the motor is located.
▶If you notice any anomaly (such as unusual noise from the fan),
switch off the device and unplug it immediately.
▶Make sure that no objects or liquids enter the interior of the fan
through any openings.
▶The fan should only be used in dry environments.
▶Protect the device from dust, moisture, sunlight and direct heat.
Ref. 33528
Publicidad
