cecotec READYWARM 2000 POWER TOWER Manual De Instrucciones página 33

Box content
1. Heater
2. Remote control
3. Instruction manual
3. OPERATION
Installation
Use four screws (M6*30) to fix the base to the bottom of the heater (as shown in the picture).
Fig. 3
Operation instructions
A. These appliances must be supplied with the appropriate voltage and frequency, and
connected to an individual electrical circuit, properly earthed, protected by a circuit breaker
in accordance with wiring regulations. The power cord of this appliance must remain
attached. Installation may only be carried out by qualified personnel in order to avoid risks.
B. Only use the heater when it is in an upright position. This electric heater is equipped with
a temperature setting. The switch at the top of the heater is used to control the 1500 W
power settings. 0 position means off. Press the switch again so that the heater operates
at high power. This will cause both the lower and upper heating elements to ignite and
radiate heat.
After turning the switch to ON position, press
will enter standby mode.
- Press twice; the display will show P1. The heater will operate at 650 W.
- Press three times; the display will show P2. The heater will operate at 1350 W.
- Press four times; the display will show P3. The heater will operate at 2000 W.
- Press to select the timer function. The interval is 1-24 hours.
Remote control buttons
The heater functions can be controlled via the remote-control buttons and the LED display.
You can also control some of the functions of your heater via the buttons on the front of the it.
once; the display will show P0. The heater
READYWARM 2000 POWER TOWER
ENGLISH
33