Publicidad
Idiomas disponibles
Idiomas disponibles
THE RBRC
TM
SEAL
The RBRC
TM
(Rechargeable Battery Recycling Corporation) Seal on the LI-ION battery
(or battery pack) indicates that the costs to recycle the battery (or battery pack) at the
end of its useful life have already been paid by Craftsman _.
RBRC
TM
in cooperation with Craftsman _ and other battery users, has established
programs in the United States to facilitate the collection of spent LI-ION batteries. Help
protect our environment and conserve natural resources by returning the spent LI-ION battery to an
authorized Craftsman _ service center or to your local retailer for recycling. You may also contact
your local recycling center for information on where to drop off the spent battery. RBRC
TM
is a
registered trademark of the Rechargeable Battery Recycling Corporation.
Problem
• Unit will not start.
• Battery won't
charge.
• Tool runs slowly.
TROUBLESHOOTING
Possible Cause
• Battery not installed properly.
• Battery not charged.
• Battery not inserted into charger.
• Charger not plugged in.
• Surrounding air temperature too
hot or too cold.
• Spool may have debris.
• Cutting line may be too long.
Possible Solution
Check battery installation.
Check battery charging
requirements.
• Insertbatteryintochargeruntilgreen
LED appears.Charge up to 8 hours
if battery totally drained.
• Plug charger into a working
outlet. Refer to "Important
Charging Notes" for more
details.
• Check current at receptacle
by plugging in a lamp or other
appliance.
• Check to see if receptacle is
connected to a light switch which
turns power off when you turn out
the lights.
• Move charger and tool to a
surrounding air temperature of
above 40 degree F (4.5°C) or
below 105 degree F (40.5°C).
• Check that the spool housing can
rotate freely. Carefully clean it if
necessary.
• Check that the cutting line
does not protrude more than
approximately 4-13/16 inches
(122mm) from the spool If it does,
cut it off so that it just reaches the
line trimmingblade.
13
Publicidad
