4. If pressing wool, cotton or linen you may choose to spray
with a burst of steam using Steam Burst Buttons. This
function is available once Steam Burst Ready Indicator
Light illuminates. See "Steam" section before applying
steam.
5. To press, lower Pressing Plate gently onto fabric and
Ironing Board. Hold there for 8-10 seconds, then lift
Pressing Plate. Repeat until you have achieved desired
crease and smoothness.
NOTE: The unit will automatically turn off the Pressing Plate
after 10 seconds in closed position. Once unit is opened, it will return to normal operation.
6. Once pressing tasks are complete, immediately turn On/Off Switch to "Off" (O) position
and unplug power cord from electrical outlet.
STEAM
IMPORTANT: Do not activate Steam Burst Buttons with unit com-
pletely closed, as this may damage unit. Best results are obtained
if Pressing Plate is held open approximately 3 in. (75 mm.) above
Ironing Board before pressing Steam Burst Buttons. For safety
reasons, do not hold Pressing Plate open more than 3 in. (75 mm.)
when using Steam Burst Buttons. Only use burst of steam for 1
second for best results. If Pressing Plate is left on fabric for more
than 10 seconds, it could damage fabric.
NOTE: When using Nylon or Silk settings, no steam is produced.
1. Hold Pressing Plate approximately 3 in. (.75 mm.) above
Ironing Board.
2. Press Steam Burst Buttons to release a burst of steam onto fabric for 1 second.
3. Lower Pressing Plate onto fabric for 8-10 seconds, then raise once again.
NOTE: If Pressing Plate is left on fabric for more than 10 seconds, it could damage fabric.
4. Repeat steps 1-3 above until fabric is smooth and wrinkle-free.
PRESSING AND STEAMING TIPS
PRESSING PANTS
1. Place Pressing Cushion under waistband and press. Continue repositioning waistband
until completely pressed.
2. To press inseam, place Pressing Cushion under area to be pressed.
3. Place pleated area on Ironing Board. Carefully fold pleats and press.
Using the
Professional Steam Press
3"
ENGLISH – 7