Publicidad
Idiomas disponibles
Idiomas disponibles
Thanks for buying a Squier Rumble series bass amplifier. Fender
bass amplifiers are legendary for providing thick, natural and bal-
anced tone that sits fat in your live or studio mix. Rumble amps are
designed by and for bass players, and we take great pride in putting
full-featured, easy-to-operate amps of the highest quality in the
hands of working and aspiring musicians everywhere.
The Rumble family can take you from home rehearsal all the way
to the 1,000-seat concert and beyond. Wherever your musical path
takes you, Rumble bass amps help get you there!
A.
INPUT: Plug your bass in here.
B.
VOLUME: Controls the loudness of the amplifier.
Rumble amps are equipped with Fender's Delta-Comp™ lim-
iter. Setting the VOLUME higher or playing more aggressively
will result in more compression and sustain!
C.
EQUALIZATION: Use these knobs to adjust overall tone and to
compensate for room acoustics. Remember, what sounds harsh
in a garage with a cement floor may have just the right edge in
a bedroom with carpet.
D.
AUX IN: Plug your media player in here for accompaniment.
The amplifier controls do not affect this input. Adjust the vol-
ume and tone of the auxiliary input at the source by using the
controls on your media player.
POWER REQUIREMENT
INPUT IMPEDANCES
PRE-AMP SENSITIVITY
POWER AMP OUTPUT
TONE CONTROLS
HEADPHONE OUTPUT
SPEAKER
RUMBLE™ 15
INPUT
VOLUME
BASS
SPECIFICATIONS
40W Max / 20W Typical
1MΩ (Input) / 10kΩ (Aux In)
60mVrms
(Full power @ 100Hz, volume at max, tone controls flat)
15W into 8Ω @ <0.3% THD, 100Hz
Bass: ±15dB @ 60Hz
110mW into 32Ω/Channel
One 8Ω, 8", Special Design
Specifications are subject to change without notice. Visit www.fender.com for additional product information.
Please visit the individual product page at:
series/rumble
for full warranty details and instructions on how to
get your amplifier serviced under warranty in U.S.A. and Canada;
see your Fender distributor for warranty details in other countries.
MID
TREBLE
AUX IN
PHONES
EQUALIZATION
E.
PHONES: Plug your stereo headphones (32 ohms minimum
impedance) in here. Speaker output from the amplifier is auto-
matically muted when the PHONES jack is in use.
F.
POWER INDICATOR: Illuminates when power is switched on to
the unit.
G. POWER SWITCH (REAR PANEL): Press to the "ON" position
to switch power on to the unit. Press to the "OFF" position to
switch power off to the unit.
H. IEC POWER CORD SOCKET (REAR PANEL): Connect the
included power cord to a grounded A/C electrical outlet in
accordance with the voltage and frequency ratings specified
on the rear panel of your amplifier.
Refer to the back cover page of this manual for a block dia-
gram of the Rumble amplifier circuitry.
Mid: ±15dB @ 630Hz
Treble: ±15dB @ 6kHz
www.fender.com/
Publicidad
